CLI Support on OpenVMS
» Table of Contents |  | | » Index | | |
| | |
| ||
| ||
OpenVMS provides a CLI command interface to the Instant Capacity software. The HP-UX command syntax can be implemented using foreign command symbols. The OpenVMS DCL ICAP command provides DCL command support.
The HP-UX command syntax can be used on OpenVMS systems by defining foreign command symbols to the iCAP images. Add the three symbol declarations below to your LOGIN.COM file or to the SYLOGIN file to define commands that use the HP-UX syntax.
$ icapmodify :== $ICAP_MODIFY
$ icapnotify :== $ICAP_NOTIFY
$ icapstatus :== $ICAP_STAT
Command options are specified as described in the HP-UX manpages for each command.
The following table shows the mapping of the HP-UX iCAP commands and their OpenVMS equivalents.
Table B-1 OpenVMS Command Mapping
HP-UX Style | OpenVMS Style |
|---|---|
icapstatus | icap show status |
icapstatus -s | icap show status/snapshot |
icapmodify -C <codeword> | icap apply codeword "codeword" |
icapmodify -c <contact> | icap set email/contact="address" |
icapmodify -f <from> | icap set email/from="address" |
icapmodify -i <system_id> | icap set system_id "id" |
icapmodify -r | icap reconcile |
icapmodify -w <warning> | icap set warning_days "days" |
icapmodify -a | icap activate /cpus=/defer/ticap |
icapmodify -d | icap deactivate /cpus/defer |
icapmodify -s | icap set active_cpus n |
icapnotify -a | icap set asset/state=on|off |
icapnotify -n | icap set notification/state=on|off |