SEND-SCSI
*********

make use of the generic SCSI-Driver. This short program allows you to send 
SCSI-command to any SCSI-device connected to a VAXstation or device 
connected to the KZQSA-Qbus-controller.

This is useful to connect a foreign device to this bus. Then you can check, 
what it sends in response of a special SCSI-command.
You can also lowlevel-format a disc-dirve, if this should be necessary. 
This can be done on the fly!

Note: MKdriver and DKdriver from DEC (in VMS) has the IO$_DIAGNOSE command
      implemented, so you can use this program also with this drivers, not
      only with devices connected to the GKdriver.

Note: Before using this program, read first VMS Version 5.3 Small Computer
      System Interface (SCSI) Device Support Manual.
      (ZK5369 ???)

CARE: You can destroy data on a disk by using this program. You yourself 
      are responsible if this happens (wrong device specified!). So, be 
      careful when using it.

Privileges used: You need DIAGNOSE and PHY_IO Privilege to use this program.

In the subdirectory are some files with SCSI-Commands. Use them as template 
to construct your own files.

If you have questions, you can contact me:

Thomas Irlet
Gruppe für Rüstungsdienste
Stauffacherstrasse 65
CH-3000 Bern 22
Tel +41 31 67 61 30
FAX +41 31 67 61 21
X.400 irlet@1=ch@2=arcom@3=grd (irlet@grd.arcom.ch)