TEXT FILE:		INSTALL.TXT

Author: Frank Dolatshahi
Date: 8/24/89
           ****************************************

	  STEPS TO PREPARE YOUR SYSTEM FOR SQUEEZER

           ****************************************

	******************* PLEASE NOTE ********************

	Even though Squeezer has been tested many times on 
	different setups, please backup your system disk 
	before installation of squeezer, just as a precaution.

   ###   Please perform the following steps in the order given   ###

	****************************************************

A-	MAKE SURE YOUR SYSTEM IS RUNNING VMS 5.0 OR HIGHER, AND
        YOU ARE LOGGED IN TO A PRIVILEGED ACCOUNT.

B-	CREATE THE DIRECTORY SYS$SYSDEVICE:[MEMPURGE] ON YOUR
	SYSTEM, SET DEFAULT TO IT ,AND CHECK TO ENSURE THAT ALL THESE FILES 
	ARE THERE:

	1-SQUEEZER.MAR
	2-SQUZ_PRM.MAR
	3-SQUZ_AST.MAR
	4-SQUZ_AST.COM
	5-SQUZ_START.COM
	6-SQUZ_STOP.COM
	7-READ_ME.1ST
	8-INSTALL.TXT (this file)


C-	YOU MAY EDIT THE FILE SQUZ_PRM.MAR TO SET UP THE PARAMETERS 
        THE WAY YOU LIKE. THESE PARAMETERS ARE EXPLAINED IN THAT
        FILE.

D-	WHEN YOU ARE READY JUST TYPE @SQUZ_SETUP.COM. TYPE THE
        DIRECTORY COMMAND TO MAKE SURE THAT SQUEEZER.EXE HAS BEEN
        GENERATED. 

E-	NOW TYPE THE COMMAND @SQUZ_AST.COM. THIS MAY TAKE COUPLE OF
        MINUTES. YOU SHOULD SEE THE REPORT OF COPYING THE IMAGE
        MEMPURGE.EXE , IGNORE THE MESSAGE REGARDING THAT ...
	IMAGE MEMPURGE COULD NOT BE REMOVED. THIS COMMAND PROCEDURE
	ALWAYS TRIES TO LOAD UP THE NEWEST MEMPURGE.EXE, AND IT TRIES TO
	REMOVE THE OLDER VERSION. 
	(Note: on a common system disk cluster or LAVC system, you need to
	 run this command procedure on only one of the nodes.)

F-	ONCE YOU GET THE $ BACK, REBOOT THE SYSTEM.

G-	WHEN SYSTEM COMES BACK UP, LOG ON TO A PRIVILEGED ACCOUNT
	AND GO INTO SDA. TYPE 'SHO EXEC' AND YOU SHOULD SEE THE 
	IMAGE 'MEMPURGE' ALONG WITH OTHER EXECUTIVE IMAGES. IF 
	YOU SEE THIS YOU ARE ALL SET TO GO. IF NOT YOU MAY WANT TO
	REPEAT THESE STEPS AGAIN AND MAKE SURE YOU HAVE VMS 5.X OR HIGHER,
	AND YOU HAVE ALL PRIVILEGES.

H-	YOU MAY NOW START THE PROGRAM BY TYPING @SQUZ_START.COM.
	WHEN YOU ARE PROMPTED FOR PROCESS NAME , ENTER A PROCESS NAME
	FOR SQUEEZER, OR JUST HIT <CR> FOR DEFAULT NAME OF 'Squeezer!!'.

I-	AS A PRECAUTION STEP, PLEASE GO THROUGH THESE INSTALLATION
 	STEPS, ANYTIME AFTER YOU PERFORM AN OPERATING SYSTEM
	UPGRADE. 

J-	PLEASE NOTE THAT THERE WILL BE SOME NEW FILES CREATED IN 
	SYS$SYSDEVICE:[MEMPURGE] BY SOME OF THE ABOVE PROCEDURES.