The font program uses the VT100 attributes in helping you to design
a different character set for a Printronix printer which has the
A-4 (12 sockets) board.

To comile the program:

	@fontasm

To build the program:

	@fontbld

Prompts for program:

	enter file name>   enter NEW if first time, else enter the saved
                           filename (with no extension)

	if NEW then

	enter terminal type>  currently, it will support PRINTRONIX and
                              DIRECT (a terminal which has dynamic font
                              ability).

	enter character index>  enter the number (1-n) of the character you
                                wish to see or modify

	when you are in character font mode, a ^Z will get you back to the
	prompt to the character index prompt.

	a ^Z at the character index prompt will get you to next command
	prompt.

	enter command>  WRITE to save character font.
	
			enter filename>  enter file name of saved character font.

			OUT to produce character font ascii program file.

			enter group number>  enter the prom set (1-6) of the
			                     character font.  It produces
					     two files Pn.RIG and Pn.LEF
                                             where n is the group number.
					     the files are suitable for
                                             downloading from the VAX to
                                             a prom programmer, but first you
                                             will have to change the record 
                                             attribute of both files to NONE.